Crestron Isys TPS-4L Operations & Installation Manual page 11

®
Crestron Isys TPS-4L
Operations & Installation Guide – DOC. 6449
FE (Net ID 02 is reserved for master control units). The Net IDs reside within all
Cresnet devices (hardware) and must match the Net ID as specified in the software
(SIMPL Windows) that runs the system. Refer to "Setting the Net ID in Device
Settings" on page 19 for details of the SIMPL Windows procedure.
The Net ID of the TPS-4L has been factory set to 03. The Net IDs of multiple
TPS-4Ls in the same system must be unique. Net IDs can be changed from a
personal computer (PC) using Crestron SystemBuilder
through the device SETUP MENU as described on page 14.
NOTE: For detailed information on establishing communication between the PC and
control system, refer to "Establishing Communications" on page 20. If
communication cannot be established, refer to the "Troubleshooting
Communications" section in the latest version of the 2-Series Control System
Reference Guide (Doc. 6256), which is available from the Crestron website
(http://www.crestron.com/manuals).
The Crestron Toolbox provides several methods to easily set or change device Net
IDs for any device on the network. The following method permits you to change the
Net ID of any device in the network through the "Network Device Tree" window.
NOTE: This method prevents you from setting duplicate IDs.
This method permits you to manually set the Net ID for any device in the network,
can be used to set any known Net IDs that may require changing, and may also be
used for non-TSID equipment. This method will not permit you to choose an ID
already in use by another device. A warning message will appear if you attempt to
use an ID that is already in use.
Duplicate Net ID Warning Message
This method does not change the Net ID as assigned in SIMPL windows. Refer to
page 19 for the SIMPL Windows ID change procedure.
NOTE: You may also use Crestron SystemBuilder to perform Network ID setup.
1. Ensure that all network devices are connected to the control system.
2. Open Crestron Toolbox and establish communications (refer to page 20).
3. Select the Network Device Tree
Device Tree. (Refer to the following figure.)
3.6-inch Wall Mount Touchpanel
™
icon, or select Tools | Network
3.6-inch Wall Mount Touchpanel: Isys
or Crestron Toolbox, or
TPS-4L • 7
®