Crestron Isys TPS-4L Operations & Installation Manual page 27

®
Crestron Isys TPS-4L
Operations & Installation Guide – DOC. 6449
Network Device Tree Sub-Menu -Functions
NOTE: Crestron Toolbox displays a customized list of functions depending on the
type of device with which it is communicating.
TCP/IP Communication
This section explains how to configure a TPS-4L to communicate over Ethernet
using TCP/IP. These procedures assume that the touchpanel has been powered up
and connected properly.
PC-to-touchpanel communications can be implemented over TCP/IP as shown in the
following diagram. TCP/IP is the fastest method of communicating between the PC
and the touchpanel.
Typical Connection Diagram when Uploading a Touchpanel Project or Firmware to the
Touchpanel via TCP/IP
1. To establish TCP/IP communications with the touchpanel, a serial
connection must be established between the PC and touchpanel. Refer to
"Indirect Serial Communication" on page 21 for instructions.
2. While connected to the touchpanel, select Functions | Ethernet
Addressing. The touchpanel's current IP address, IP mask and default
router are displayed.
3.6-inch Wall Mount Touchpanel
3.6-inch Wall Mount Touchpanel: Isys
TPS-4L • 23
®