Crestron Isys TPS-4L Operations & Installation Manual page 15

®
Crestron Isys TPS-4L
Operations & Installation Guide – DOC. 6449
4. Remove the template, and then cut out and remove the traced shape to
produce the required opening.
NOTE: Before inserting the TPS-4L in the mounting hole, ensure that all required
cables have been installed in the wall.
5. Install the four supplied #6x 2-½" screws and mounting clips as shown in
the following diagram (two on the top and two on the bottom).
•
Insert the screws through the touchpanel flange and then through the
larger hole in the mounting clip.
•
Thread the screws through the smaller hole in the mounting clips and
tighten the screws only enough that the mounting clips are brought
flush with the rear of the touchpanel flange. Do not compress the
mounting clips at this time.
Attaching the Screws and Mounting Clips
6. Connect the Cresnet cable, using the supplied mating connector, to the
Cresnet port; attach the Ethernet cable, if required, and position the TPS-4L
in the mounting hole.
3.6-inch Wall Mount Touchpanel
3.6-inch Wall Mount Touchpanel: Isys
TPS-4L • 11
®