Hardware Hookup; Configuring The Touchpanel - Crestron Isys TPS-4L Operations & Installation Manual

®
Crestron Isys TPS-4L
MAIN MENU
This menu can also be obtained via
digital reserved join number, 17242.
Operations & Installation Guide – DOC. 6449

Hardware Hookup

Refer to the following hookup diagram and, if there is to be an Ethernet connection,
connect that cable first.
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the specifications table. Consideration
must be given if installed in a closed or multi-unit rack assembly, inside a closed
desk, or in a closed podium since the operating ambient temperature of these
environments may be greater than the room ambient. Contact with thermal insulating
materials should be avoided on all sides of the unit.
Hookup Connections

Configuring the Touchpanel

NOTE: The only connection required to configure the touchpanel is power. Refer to
"Hardware Hookup" above for details.
NOTE: The touch screen responds to both finger and stylus commands. Since the
screen is small, Crestron recommends that a stylus (not supplied) be used to ensure
the accuracy of commands. Use a stylus that will not damage the surface of the
screen.
Prior to normal operation, it is advisable to configure the unit using a series of setup
screens. The MAIN MENU for configuring the touchpanel appears when a finger (or
stylus) is held (approximately five seconds) to the touchscreen when power is applied
or when the reset button is pressed.
Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four
buttons: Touch Screen Calibration, Exit and Run Program, Setup, and
Diagnostics.
Selecting Exit and Run Program verifies that all of the setup information has been
saved to EEPROM and displays the main page that has been programmed into the
touchpanel. The remaining buttons on the MAIN MENU open other menus, which are
discussed in subsequent paragraphs.
3.6-inch Wall Mount Touchpanel
3.6-inch Wall Mount Touchpanel: Isys
TPS-4L • 13
®