Calibration Menu; Setup Menu - Crestron Isys TPS-4L Operations & Installation Manual

3.6-Inch Wall Mount Touchpanel

CALIBRATION MENU

SETUP MENU

INTERFACE MENU
14 • 3.6-inch Wall Mount Touchpanel: Isys
Calibration Menu
Calibration of the touchscreen is required if the active touch area of a button does not
coincide with the button's image. Select the Touch Screen Calibration button to
display the CALIBRATION MENU, as shown to the left. The CALIBRATION
MENU offers the choice to initiate calibration with the Perform Calibration button
or return to the previous screen with the Return button. Choose an option by
touching the appropriate button.
If you need to calibrate the touchpanel, the screen displays the message "Touch
Upper Left" centered on the panel with a cross hair in the upper left corner. Touch
the cross hair to initiate calibration. Another message, "Touch Upper Right", appears
with a cross hair in the correct corner. Touch the cross hair. A final message, "Touch
Lower Right", appears with a cross hair in the correct corner. Touch the crosshair to
finish the calibration and return to the MAIN MENU.
NOTE: When touching each crosshair during calibration, be as accurate as possible.
Use a stylus or the tip of a capped pen or the eraser end of a pencil. To cancel
calibration and return to the CALIBRATION MENU without saving calibration data,
create a calibration error by touching the screen in an area that is opposite from the
instructed area.
Setup Menu
To obtain the SETUP MENU, shown to the left, press the Setup button from the
MAIN MENU. The SETUP MENU offers a series of buttons, which open additional
menus and screens that are detailed in subsequent paragraphs. After setup parameters
have been set, select the Return button to return to the MAIN MENU.
NOTE: For convenience, the current CRESNET ID setting is displayed in the lower
left corner.
NOTE: All touchpanel settings are automatically saved in non-volatile memory.
Interface
The touchpanel communicates with a control system to activate commands or to
display feedback from components within the system. The communication interface
must be correctly specified or communication will not occur. To set communication
parameters, first select the Interface button on the SETUP MENU to display the
INTERFACE MENU screen, shown to the left. Then, use the CRESNET ID UP and
DOWN buttons to set the Cresnet network identity (CRESNET ID).
Use the other buttons on the screen to enable/disable the preferred communications
protocol: Cresnet II, Ethernet, or CIP (Crestron Internet Protocol).
Cresnet II buttons determine the touchpanel's communication mode. Select Enable
for normal Cresnet communications (default); select Disable to disable the Cresnet
communications interface.
The Ethernet Enable and Disable buttons determine the touchpanel's ability to
communicate with other devices via Ethernet.
The CIP Enable and Disable buttons determine the touchpanel's ability to
communicate with other Crestron devices using CIP. CIP must be enabled for the
touchpanel to communicate with other Crestron Ethernet devices.
After the Cresnet ID setting has been verified and the communications protocol has
been selected, press Return to save the settings and return to the SETUP MENU.
®
TPS-4L
Crestron Isys
Operations & Installation Guide - DOC. 6449
®
TPS-4L