Uploading And Upgrading; Communication Settings - Crestron Isys TPS-5000L Operation Manual

12 Inch Lectern/Wall Mounted Touchpanel

Uploading and Upgrading

36 • 12 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-5000L
Assuming a PC is properly connected to the entire system, Crestron programming
software allows the programmer to upload programs and projects to the system and
touchpanel after their development. However, there are times when the files for the
program and projects are compiled and not uploaded. Instead, compiled files may be
distributed from programmers to installers, from Crestron to dealers, etc. Even
firmware upgrades are available from the Crestron website as new features are
developed after product releases. In those instances, one has the option to upload via
the programming software or to upload and upgrade via the Crestron Viewport.
NOTE: Currently, the Crestron Viewport is only available as a pull-down command
from SIMPL Windows and VT Pro-e (Tools | Viewport). The Viewport utility
accomplishes multiple system tasks, primarily via an RS-232 or TCP/IP connection
between the control system and a PC. It is used to observe system processes, upload
new operating systems and firmware, change system and network parameters, and
communicate with network device consoles and touchpanels, among many other
tasks. Viewport can also function as a terminal emulator for generic file transfer. All
of these functions are accessed through the commands and options in the Viewport
menus. Therefore, for its effectiveness as a support and diagnostic tool, the Crestron
Viewport may be preferred over development tools when uploading programs and
projects.
The following sections define how one would upload a SIMPL Windows program,
VT Pro-e project or upgrade the firmware of the TPS-5000L touchpanel. However,
before attempting to upload or upgrade, it is necessary to establish communications.

Communication Settings

Connection of a PC to the TPS-5000L touchpanel can be direct via the RS-232 port
on the touchpanel or through a control system (Cresnet). Both methods of connection
provide setup for RS-232 communication.
To prepare the TPS-5000L for uploading or upgrading, refer to the following figure
for a typical connection diagram.
Typical Connection Diagram when Uploading a Project
Cresnet
Control System
To prepare the TPS-5000L for uploading or upgrading directly from a PC, refer to
the following figure. Connect the RS-232 port of the computer directly to the RS-232
port of the touchpanel. Refer to page 18 for RS-232 cable information.
Crestron Isys™ TPS-5000L
RS-232
Operations Guide - DOC. 5783A