Setup
1
Installing the Roller
No Parts Required
Procedure
The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro dealer and
install it on the cutting unit, as follows:
1.
Remove the plow bolt, washer, and flange nut
securing one of the height-of-cut arms to the
cutting unit side plate
1. Roller
2. Plow bolt
3. Height-of-cut arm
2.
Loosen the roller-mounting screws in the
height-of-cut arms.
3.
Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit.
4.
Slide the height-of-cut arm onto the roller shaft.
5.
Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed.
6.
Center the roller between the height-of-cut arms.
(Figure
3).
Figure 3
4. Adjusting screw
5. Flange nut
6. Roller-mounting screw
7.
Tighten the roller-mounting screws.
8.
Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.
2
Installing the Cutting Unit
to the Traction Unit
No Parts Required
Procedure
Install the cutting unit to the traction unit; refer to
your traction unit Operator's Manual for installation
instructions.
3
Adjusting the Cutting Unit
No Parts Required
Procedure
1.
Access the cutting unit; refer to
Cutting Unit (page
2.
Adjust the bedknife to the reel; refer to
the Bedknife after Grinding, Backlapping, or
Disassembly (page
g310842
3.
Adjust the height of cut; refer to
Height-of-Cut Adjustment (page
4
Accessing the
6).
Adjusting
8).
Performing the
9).