Table of Contents
Advertisement
2
1
Figure 13
1. Lift lever
2. Button
Operating the Attachment
Power Lift
The attachment power lift (Fig. 14) is used to raise and
lower attachments.
Raising Attachments
1. Start the engine, refer to; Starting and Stopping the
Engine; in tractor Operator's Manual.
2. Pull the lift lever in the up direction to raise the
attachment lift (Fig. 14). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Start the engine, refer to; Starting and Stopping the
Engine; in tractor Operator's Manual.
2. Push the lift lever in the down direction to lower the
attachment lift (Fig. 14).
3
m–2514
3. Dial-A-Height
11
2
1
Figure 14
1. Lift lever UP
Adjusting the Dial-A-Height
The Dial-A-Height control (Fig. 13) is used to limit the
downward travel of the attachment. The Dial-A-Height
knob is rotated to change the location of this stop, up or
down.
1. Raise the attachment lift; refer to Raising an
Attachment. In the raised position the Dial-A-Height
knob (Fig. 13) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 13) will show the
change, high to low, in attachment lift height as
adjustment is made.
Adjusting Height-of-Cut
The rear gauge wheels are adjusted in different hole
location for 1-1/2 to 3-1/2 in. (4–9 cm) height-of-cut.
1. Pull height-of-cut lever out to disengage from quadrant.
Adjust height-of-cut to the desired level. Release lever
inward to lock into quadrant (Fig. 15).
m–2454
2. Lift lever DOWN
Advertisement
Table of Contents
