Configure For Country/Region And Model (Function Code 74); Installing The Firmware (Sub Firmware And Main Firmware); Checking Firmware Version - Brother HLL3290CDW Service Manual

1.1 Configure for Country/Region and Model
(Function code 74)
Perform settings for a country/region as described in
model (Function code 74)" in Chapter
1.2 Installing the Firmware
(Sub Firmware and Main Firmware)
1.2.1

Checking firmware version

Check whether the firmware installed on the machine is the latest version. If it is the latest
version, there is no need to install the firmware. If it is not, be sure to install the firmware to the
machine as described in
<How to check firmware version>
(1) Press and hold the
state.
(2) Press the blank field at the bottom.
(3) Press the [*], [2], [8], [6], and [4] on the LCD in this order, and the machine enters into
maintenance mode.
(4) Press the [2], and then the [5] in the initial state of maintenance mode. Then, the Main
firmware version information is displayed on the LCD.
(5) Next, press the [Start] or [Mono Start] to display the version information of the Sub
firmware on the LCD and check the information.
Memo:
You can also check the Sub firmware and Main firmware version by implementing "Print
maintenance information (Function code 77)" (refer to
information (Function code 77)" in Chapter
5.
"1.2.2 Installing firmware" in this
for approximately five seconds while the machine is in the ready
5).
4-2
"1.3.28 Configure for country/region and
chapter.
"1.3.29 Print maintenance
Confidential