Table of Contents
Advertisement
9.13 Panel unit
(1) Remove the four Taptite cup B M3x10 screws. Release each Hook to remove the Panel
unit. Disconnect the Panel flat cable from the Panel PCB.
Note:
• When removing the Panel unit, DO NOT pull the Panel unit strongly because it is
connected to the Panel flat cable.
<Touch panel models>
Panel PCB
<Non-touch panel models>
Panel PCB
Assembling Note:
• If you replaced the Panel unit, refer to
PANEL PCB" in Chapter 4
Panel flat
cable
Panel flat cable
Fig. 3-39
"4. IF YOU REPLACE THE LCD, PANEL UNIT OR
to configure settings.
3-58
Hooks
Panel unit
Taptite cup
B M3x10
Hooks
Confidential
Advertisement
Table of Contents
Troubleshooting
