9.36 Paper eject ASSY
(1) Raise the Arm R approximately 135 degrees to remove it from the Paper eject ASSY.
(2) Pull out the Eject gear shaft.
(3) Remove the three Taptite bind B M4x12 screws. As shown in the figure, use a screwdriver
to release the Boss on the right side of the Paper eject ASSY, and then remove the Paper
eject ASSY.
Eject gear
shaft
Taptite bind B M4x12
Boss
Fig. 3-105
3-117
Arm R
Approx.135°
Taptite bind B M4x12
Paper eject ASSY
Boss
Taptite bind B M4x12
<Back side>
Paper eject ASSY
Confidential