Table of Contents
Advertisement
1.3
Initializing the EEPROM of the Main PCB
(Function code 01)
Initialize the EEPROM of the main PCB in accordance with
parameters (Function code 01, 91)" in Chapter
1.4
Adjusting Touch Panel (Function code 61)
Perform adjustment of touch panel in accordance with
code 61)" in Chapter
1.5
Continuous Adjustments of Density and Registration
Sensor (Function code 73)
Perform continuous adjustments of density and registration sensor in accordance with
Continuous adjustments of density / registration sensor (Function code 73)" in Chapter
1.6
Acquisition of White Level Data (Function code 55)
Perform acquisition of white level data in accordance with
set CIS scan area (Function code 55)" in Chapter
1.7
Setting the Serial Number (Function code 80)
<Operating procedure>
(1) Press the [8], and then the [0] in the initial state of maintenance mode. "MACERR_01:****"
is displayed on the LCD.
(2) Press the [Start] or [Mono Start] several times until "USB:************" is displayed on the LCD.
(3) Press the [9], [4], [7], and [5] in this order to enter the edit mode.
(4) Use the keypad to enter the first digit of the serial number. The second digit starts to flash.
Enter the second digit to the 15th digit similarly.
Memo:
When you enter alphanumeric characters other
than A, B, C, D, E and F, see the right table and
press the corresponding key until the desired
character is displayed.
(5) Press the [SET], and the new serial number is saved. The machine returns to the initial
state of maintenance mode.
5.
4-5
"1.3.1 Initialize EEPROM
5.
"1.3.19 Adjust touch panel (Function
"1.3.17 Acquire white level data and
5.
Keypad
4
4 → G → H → I
5
5 → J → K → L
6
6 → M → N → O
7
7 → P → Q → R → S
8
8 → T → U → V
9
9 → W → X → Y → Z
"1.3.27
5.
Assigned characters
Confidential
Advertisement
Table of Contents
Troubleshooting
