Table of Contents
Advertisement
Commissioning
High voltage
Certain parts inside the device carry dangerous high voltage. The housing must be closed and
grounded before switching the device on.
High pressure or corrosive media
The sensor connected to this device can be operated with high pressure and corrosive media.
Therefore improper handling of the device can lead to serious injuries and/or considerable
material damage.
Commisioning the device
• Switch on the power supply. The device runs a self-test which lasts about 30 seconds.
During the self-test the smartPLUG data is pulled from the sensor. Afterwards the device is ready
for operation and starts measuring.
The tag data can then be changed permanently in the transmitter. These data are not read in
again until a new sensor is connected.
Note
Gas/air in the line
If there is gas/air in the measuring tube or in the pipeline after assembly, a flashing "F" appears
at the top of the first line in the display. The flowing medium removes the gas/air occlusions from
the tag and the flow can be measured without interference after a few minutes.
6.1
Operating TRANSMAG 2
TRANSMAG 2 can optionally be operated in the following ways:
• via the local display
• via HART or Profibus
• with a PC/laptop and SIMATIC PDM software
Note
The following explains how to operate the device via the local display.
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC
WARNING
WARNING
6
41
Advertisement
Table of Contents
