Table of Contents
Advertisement
Description
3.3 BUS Communication
• Slurry mode
• Parameters can be specifically selected and modified, e.g.:
– Operating parameters such as measuring range, physical dimensions or device
– Limits for flow, counter configurations
– Noise suppression using separate interference suppression and damping as well as
– Automatic mains synchronization
– Display parameters (freely configurable text display)
– Display in volume or mass units
– Density as constant input value for conversion of volume into mass
– Low flow cut-off
– Forward and reverse flow measurements
– Flow direction display and evaluation
– Diagnostics functions and control values
– PROFIBUS address
– Functions of analog output: proportional flow, failure signal
– Functions of digital output 1 (transistor): pulse output, frequency output proportional to
– Functions of digital output 2 (relay): alarm, forward or reverse flow signal, min. or max.
– Simulation of output signal via analog output, digital output 1 and digital output 2
– Option: digital output 2 as digital input for resetting counter values or for interruption in
3.3
BUS Communication
SITRANS FM TRANSMAG 2 is available with HART or PROFIBUS communication.
• The HART protocol is superimposed on the analog output (current output). This
communication capability permits parameterization of the device using the HART
communicator or a PC/laptop and SIMATIC PDM software in addition to local operation.
• In the PROFIBUS PA version, the analog output and the digital output 2 are replaced by the
digital PROFIBUS PA output. Parameterization of the device is then possible using PROFIBUS
communication and SIMATIC PDM in addition to local operation.
16
information
hysteresis functions
flow, alarm, forward or reverse flow signal, min. or max. limit for flow and counter
limit for flow and counter
measurement (PZR)
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC
Advertisement
Table of Contents
