Siemens SITRANS F TRANSMAG 2 Operating Instructions Manual page 12

Safety notes
2.2 Laws and directives
• Overvoltage category II
• Pollution degree 2
CE-marked equipment
The CE marking on the device symbolizes the conformity with the following European directives:
Electromagnetic compatibili‐
ty EMC
2014/30/EU
Low voltage directive LVD
2014/35/EU
Pressure equipment direc‐
tive PED
2014/68/EU
2011/65/EU RoHS
The SITRANS FM magnetic-inductive measuring devices comply with protection class I.
Improper device modifications
Risk to personnel, system and environment can result from modifications to the device,
particularly in hazardous areas.
• Only carry out modifications that are described in the instructions for the device. Failure to
12
NOTICE
Material compatibility
Siemens Flow Instruments can provide assistance with the selection of wetted sensor parts.
However, the full responsibility for the selection rests with the customer and Siemens Flow
Instruments can take no responsibility for any failure due to material incompatibility.
WARNING
observe this requirement cancels the manufacturer's warranty and the product approvals.
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to elec‐
tromagnetic compatibility
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to the
making available on the market of electrical equipment designed
for use within certain voltage limits
Directive of the European Parliament and of the Council on the
harmonisation of the laws of the Member States relating to the
making available on the market of pressure equipment
Directive of the European Parliament and the Council on the re‐
striction of the use of certain hazardous substances in electrical
and electronic equipment
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC