Connecting
The sensor cable shield is connected to the transmitter and sensor as follows:
1. Bend the cable shield back over the clamping piece of the cable gland.
2. Push the clamping piece with the sensor cable into the threaded bush of the cable gland
turning it slightly to the right.
3. Tighten the lock nut on the threaded bushing until the cable is connected tightly (IP67)
Figure 5-7
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC
①
Electrode cable
②
Magnetic current cable
Signal transmission from the sensor to the transmitter
5.5 Step 3: Connecting terminal box and transmitter
Connecting
39