Specifying The Time Zone - Konica Minolta PCL-400 User Manual

– If an NTP server was specified:
The date and time that data is sent with the Scan to E-Mail or Scan to FTP
operation are automatically added to the data at the same time that the
transmission date and time are recorded in the transmission log.
– If an NTP server was not specified:
Only a transmission number is added to data sent with the Scan to E-Mail
or Scan to FTP operation; the transmission date and time are not added to
the data. In addition, the date and time are not recorded in the transmission
log.
– For the NTP server address, consult with the network administrator.
The message "ACCEPTED" appears, and then the "USER SETTING" menu
appears again.
7
Press the [Reset] key.
The time is acquired from the NTP server, and then the time on the machine is
set.

Specifying the time zone

1
Press the [Utility] key in the control panel.
2
Press the [,] or [+] key until "ADMIN. MANAGEMENT" is selected, and
then press the [OK] key.
7-48