Table of Contents
Advertisement
5
In the "NETWORK SETTING" menu, press the [,] or [+] key until "IP AD-
DRESS SETTING" is selected, and then press the [OK] key.
6
Press the [,] or [+] key until "AUTO" or "SPECIFY" is selected, and then
press the [OK] key.
–
If "AUTO" was selected, the IP address will automatically be obtained
from the DHCP server. After the message "ACCEPTED" appears, the
"NETWORK SETTING" menu appears again.
–
If "SPECIFY" is selected, a screen appears, allowing you to specify the IP
address. Continue with step 7.
–
"AUTO" is available only if a DHCP server is on the network. If "AUTO"
is selected, it will not be necessary to specify the subnet mask or gateway
settings.
7
Use the keypad to type in the IP address, and then press the [OK] key.
7-11
Advertisement
Table of Contents
Troubleshooting
