Setting Of Measurement Condition - Iwatsu SY-8218 Instruction Manual

■

6.4 Setting of measurement condition

● The measurement condition is set.
① While referring to Table 6-3, move the edition cursor to Edit Box of the measurement condition to be entered on Excited Conditions and
press to determine the selection.
② When Popup List opens, move the edition cursor to the item to be set and press
➂ When Popup Edit Box opens, use the ten key to enter the number and press
changed and press
[Explanatory note] Bold: Factory settings
Items
Function
Calc.
Sine wave
Frequency
Square
wave
Fixed Parameter
(Target parameter)
Tolerance
 6-2: μ mode cannot select a square wave. This product generates the symmetry square wave with Duty50 .
. Or, rotate to change the number. Press
Table 6-3 Measurement condition
Selectable items/ input rules
Sine
Pulse
Normal
μ
SY-8218 10Hz to 10MHz
SY-8219 10Hz to 1MHz
100
10Hz to 1MHz
Bm
(Max. magnetic flux density)
Hm
(Max. magnetic field)
I1m ( excitation current)
Max.
V2m (
Max. induced voltage)
1
0.1~100%
1
to determine the setting.
. Or move the edition cursor to the number to be
to determine the setting.
Sine wave
6-2
Square wave
Selects calculation mode.
Selects a frequency of excitation signal.
0.001 to
6-3
Selects and sets a target parameter value for
99999
measurement.
6-3
Sets the tolerance X. The tolerance X is used for the
criteria to finish measurement; i.e. X [%] is the ratio of
an actual value to a target parameter setting value
and if X is reached, measurement finishes.
33
B-H ANALYZER SY-8218 / SY-8219
Description
Selects a type of excitation signal.