Iwatsu SY-8218 Instruction Manual page 6

Read the following safety information.
● Always use this product with a specified power
supply voltage.
If not, an electric shock, fire, or failure may occur. The range of operating voltage to be used
is stated on the rear panel.
This product runs on AC power supply of single-phase, 50/60Hz and AC100-240V.
No voltage selection is required, since this product automatically adapts to the power supply
voltage.
● Strictly observe items below when handling the
power cord.
If not, an electric shock or fire may occur. If the power cord is damaged, contact Iwatsu
office or our sales distributors for repair.
 Do not modify the power cord.
 Do not forcibly bend the power cord.
 Do not twist the power cord.
 Do not bundle the power cord.
● Do not touch the plug of the power cord with wet
hands.
If not, an electric shock may occur.
● Do not make metal touch the blade of the power
plug.
If not, an electric shock or fire may occur.
● Do not plug too many leads into a single receptacle.
If not, a fire or overheating may occur.
● If thunder sounds, remove the power plug of this
product from the receptacle and do not use it.
If not, a fire or electric shock may occur.
● Do not remove the operation panel.
Since a high-voltage part exists inside, touching it may result in an electric shock. When
inspecting or calibrating this product, contact Iwatsu office or our sales distributors.
Warnings
 Do not pull the power cord.
 Do not heat the power cord.
 Do not let the power cord get wet.
 Do not put heavy objects on the power cord.
IV
Read the next page.
(Conti nued)