Iwatsu SY-8218 Instruction Manual page 9

Read the following safety information.
● Do not place any object on this product.
Otherwise, the cover may contact the internal circuits causing an electric shock, fire, or
failure.
● Always use this product only within the rated operating range.
If used over the rated range, failure may occur. The allowable range is as follows:
 Only indoor use
 Temperature: 5C to 35C
 Humidity: 85  RH (35C, non-condensation)
● Do not expose this product to direct sunlight or high humidity.
If not, heat may accumulate inside this product, resulting in a fire.
● Do not place this product in a location with excessive moisture or dust.
If not, an electric shock or fire may occur.
● Do not expose this product to oil smoke or steam; e.g. besides cooking table or
humidifier.
A fire or electric shock may occur.
● Do not use any damaged cable or adaptor.
Otherwise, an electric shock or fire may occur.
● If this product will not be used for a long time, remove the power plug from the
receptacle for safety.
● When transporting this product, remove the measurement POD from the main unit
and use the packing material provided at the time of purchase or packing material
equivalent at least.
Excessive vibration or shock applied to this product during transportation may cause it to
malfunction, resulting in a fire. The case where a failure or damage occurs when
transporting this product with the measurement POD attached to the main unit shall not
be guaranteed.
If there is not a proper packing material/ shock absorber, contact Iwatsu office or our sales
distributors. When having this product transported by a shipping company, write "Precision
Instrument - Handle With Care" on each side of the packing box.
● When cleaning this product, remove the power plug from the receptacle for safety.
Use dry cloth to wipe water drops away.
If not, an electric shock or fire may occur.
● When turning on the switch on the rear of this product, a low frequency sound may
be generated. It does not affect characteristics and the life at all.
It is caused by a low frequency vibration in transition of chock coil for high-frequency
measures.
●This instrument is an equipment of Class A (Industrial electromagnetic environment).
There may be a difficult possibility about keeping the electromagnetic compatibility
in environments other than industrial due to conducted as well as radiated
disturbances. Avoid use in the residential areas, except when you do measures to
which the user decreases the electromagnetic emissions to prevent interference
because there is a possibility to cause interference for other equipment.
Cautions
VII
(Conti nued)