Save/ Recall Of Data - Iwatsu SY-8218 Instruction Manual

■

6.11 Save/ recall of data

● This product can save measurement data and the like in the USB memory as shown in Table6-7. And it can recall the data from the USB
memory.
Function Type
Setup
Save
(storage) Measurement condition
Data
and measurement data
Setup
Recall
(reading out)
Measurement condition
Data
and measurement data

6-8: Never alter the content of the save file. If an altered file is read out resulting in wrong operation or failure, this product shall not be
guaranteed and repaired.

6-9: Reference waveform (Storage waveform) cannot be saved. In addition, if a measurement condition is changed and no
measurement is made under the changed condition, the measurement data cannot be saved. Only the measurement condition can
be saved.
① Insert the USB memory into the USB port of this product.
② When is pressed while the measurement screen appears, selection menu for
Save/Recall is displayed.
(See Fig.6-27.)
③ Move the edition cursor to a desired function and press
to display selection menu of Setup/Data (see Fig.6-28).
Press of
④ Move the edition cursor to a desired data type and press
to display the corresponding Save As screen.
(See Fig.6-29)
⑤ Operation after this step is the same as
■
" 6.10 USB memory output of screen hardcopy."

Never remove the USB memory from the USB port during Save/Recall operation. A file should not be generated normally.
Table 6-8 Save/ recall of data
Objective File format
Only measurement
condition
Delimited by tab
CSV format
Only measurement
condition
Delimited by tab
CSV forma
allows the screen to return to selection menu for Save/Recall.
Extension
*6-8 .set
.mes
.set
.mes
or press
49
B-H ANALYZER SY-8218 / SY-8219
Description
Only measurement condition is saved.
The measurement condition and Current
measured under that condition are saved.
The measurement condition is read out and is set for
this product.
The measurement condition and measurement data
are read out, the measurement conditions set for this
product and the measurement data is displayed as
Current waveform.
Fig.6-27 Save/Recall selection menu
Fig.6-28 Setup/Data selection menu
Fig.6-29 Save As screen for Setup
*6-9
waveform