Table of Contents
Advertisement
Titan 165/ 110 Technical Service Manual
1.0 Servicing
D o not w ear ties, loose fit clothing or
dangling jew elry w hile operating or
servicing the lam inator. T hese item s can get
caught in the nip and choke you or you can
be crushed or burned.
This section contains the same information as in
the Operator's Maintenance section with the addition of
maintenance tasks performed by qualified service
personnel.
Qualified
• Any engineer that has experience with electrical
and mechanical design of lamination equipment. The
engineers should be fully aware of all aspects of safety
with regards to lamination equipment.
• Any commissioning or service engineer must be
of competent nature, trained and qualified to GBC Pro-
Tech standards to fulfill that job. This person will have
completed and passed the full service training course from
GBC Pro-Tech.
• Any GBC Technician, GBC Specialist, and / or
GBC Pro-Tech Technician that has been through the GBC
Pro-Tech service training course.
© GBC Films Group October 2000
W AR N IN G
1.1 Service schedule
Daily
• Clean the rollers.
( See cleaning in this section )
• Clean the machine.
( See cleaning in this section )
• Inspect the electrical cord for damage.
( If damaged, you should replace or
repair it immediately )
• Inspect the footswitch cord for damage.
( If damaged, you should replace or
repair it immediately )
Monthly
• Adjust the main roller nip if needed.
( See calibrations in Section 2 )
• Adjust the pull roller nip if needed.
( See calibrations in Section 2 )
• Check the rewind chain tension.
( The only chain that can be
tensioned )
• Check all safety devices on the laminator
( Shields, table and E-Stops )
• Inspect the area around the laminator for
possible hazards.
( dust buildup, combustible items
stored too close, etc. )
Servicing
Page 1 - 1
Advertisement
Table of Contents
