Table of Contents
Advertisement
Parts changing
3.3 Upper rollers
Tools required
• One set metric allen wrenches
• Snap ring pliers
• Rubber mallet
• Second person
3.3.1 Removing the upper roller(s)
a) Lower the rollers, then remove the cabinets as
described in Section 3.1.1.
D rive s id e
c a b in e t
P re s s u re p la te
Page 3 - 6
F ee d ta b le
Titan 165/ 110 Technical Service Manual
b) Remove the pressure plate by pulling in on the
two locator pins.
c) Remove the front feed table by pulling on the safety
pin located under the table on the drive (left) side
of the machine from the front opoerating position.
d) Remove the front safety shield by rasing the shield
then pull on the locater pin located on the control
(right) side of the machine from the front operating
position.
e) Remove the upper and lower heaters as described
in Section 3.2.1.
S a fe ty s h ield
© GBC Films Group October 2000
C o n tro l sid e
c a b in e t
R o lle r lift
h a n d le
U n w in d b ra k e
h a n d le
Advertisement
Table of Contents
