Table of Contents
Advertisement
Parts changing
3.2 Heaters
D o not perform this procedure unless
the heaters have rem ained off for a
m inim um of 4 hours.
Tools required
• 8 mm wrench
• 1 pair safety gloves
• #2 phillips screw driver
3.2.1 Removing the heater(s)
a) Remove all power to the laminator.
b) Remove the cabinets as described in Section
3.1.1.
Page 3 - 4
W AR N IN G
Titan 165/ 110 Technical Service Manual
c) Remove the nut securing the heater wire to the
end of the heater being removed using an 8 mm
wrench. Do this for both sides.
d) Use the 8 mm wrench to remove the nut
securing the heater to the heater support plate.
Do this for both sides.
e) On the control side only: ( upper ) Remove the
two phillips head screws securing the heater
bracket to the heater support arm. ( lower )
Remove the two phillips head screws securing
the heater support arm from side frame.
C AU T IO N
A lw ays w ear safety gloves w hen
handling glass quartz heaters.
f) Carefully slide the heater out from the control
side.
© GBC Films Group October 2000
Advertisement
Table of Contents
