Table of Contents
Advertisement
Parts changing
IN F O R M AT IO N
If your chain has a m aster link, you
m ay rem ove the chain by disconnecting
the m aster link.
g) Use a 6 mm allen wrench to remove the bolt and
washer to the gear reducer sprocket assembly.
h) Use a 17 mm wrench to remove the nut, washer,
spring, thrust washer and sprocket from the clutch
assembly.
i) Use a 3 mm allen wrench to loosen the set screws
to the lower pull roller and lower main roller
sprockets.
Page 3 - 10
Titan 165/ 110 Technical Service Manual
j) Carefully remove the chains and sprockets
associated with the lower rollers.
k) With a #2 phillips head screw driver, remove the
upper bolt securing the lift plate spring.
l) With a #2 phillips head screw driver, remove the
bolt and washer to the lift plate guide.
m) Use the snap ring pliers to remove the two snap
rings on the main roller and the two snap rings on
the pull rollers.
n) Remove the main roller and pull roller port plates
using a 4 mm allen wrench.
o) Carefully lift up the lower roller then carefully slide
the roller out from the roller port in the side frame.
© GBC Films Group October 2000
Advertisement
Table of Contents
