Table of Contents
Advertisement
Titan 165/ 110 Technical Service Manual
3.4.2 Replacing the lower roller(s)
a) Replace the lower roller bearings on both ends of
the roller.
b) Carefully replace the roller from the control side
of the machine. The roller bearing should be
shouldered against the inside of the side frmae.
c) Replace the drive side roller port plate and secure
in place with the four hex bolts and tighten using a
4 mm allen wrench.
d) Replace the drive side lift plate assembly and secure
in place with the snap ring.
e) Secure the lift plate spring and tighten the phillips
head bolt using a #2 phillips head screw driver.
C lu tc h a s s e m b ly
P u ll ro lle r s p ro c k e t
M o d ifie d s p ro c k e t
© GBC Films Group October 2000
f) Replace the washer and bolt to the lift plate guide
and secure in place with the #2 phillips head screw
driver..
g) Carefully replace the chain and the three sprockets
associated with the lower pull roller drive.
h) Carefully replace the chain and the two sprockets
associated with the lower main roller drive.
i) Measure the distance of the clutch sprockets from
the side frame to properly align the related
sprockets.
j) Replace the upper rollers as described in Section
3.3.2.
k) Replace the heaters as described in Section 3.2.2.
l) Replace the cabinets as described in Section
3.1.2.
m) Replace the safety shield, feed table and pressure
plate.
M a in ro lle r s p ro c k e t
Parts changing
Page 3 - 11
Advertisement
Table of Contents
