Clutch Adjustment - GBC TITAN 165 Instruction Manual

Calibrations
f) Use the small flat tip screw driver to remove the
contact block to the emergency stop buttons.
g) Use the small flat tip screw driver to remove the
control panel from the cabinet.
h) Adjust the springs on the lift assembly plate for
the pull rollers as needed to achieve satisfactory
output quality.
P u ll ro lle r n ip
a d ju s tm e n ts
i) When finished, replacethe drive side cabinet, the
control side cabinet, the unwind brake handles
and the lift handle.
Page 2 - 4
Titan 165/ 110 Technical Service Manual

2.3 Clutch adjustment

This calibration adjusts the tension of the web
between the main rollers and the pull rollers.
Tools required
• Two rolls of thermal film ( see film width below )
T110 = 41 in. rolls / T165 = 51 in. rolls
• 17 mm wrench
• # 2 phillips screwdriver
• Small flat tip screwdriver
a) Set up he machine as you would for two sided
thermal encapsulation.
b) After webbing the machine, run the machine while
observing the quality of the output. If the output
quality is good, STOP. If not, continue with the
next step.
G ood ouptut
© GBC Films Group October 2000
Poor ou ptut