Table of Contents
Advertisement
Titan 165/ 110 Technical Service Manual
10.0 Glossary of terminology
The glossary will assit you in
understanding some of the terms used in this
service manual.
10.1 Glossary
Control panel: refers to the panel on the right
side cabinet from the front which aloows an
operator to control the operations of the
machine.
Control side: refers to the right hand side of
the machine from the front operating position.
Drive side: refers to the left side of the machine
from the front operating position.
I/O Board: refers tothe main input / output
printed circuit board.
Main rollers: refers to the two rolls closest
to the front of the machine.
Nip: refers to the space between two rollers.
Nip impression: refers to the footprint left in
laminate when a dwell has occurred.
Web: refers to the material going passing
through the machine.
© GBC Films Group October 2000
Pull rollers: refers to the two rolls closest to
the rear of the machine.
Qualified: Refers to any engineer that has
experience with electrical and mechanical
design of lamination equipment. The engineers
should be fully aware of all aspects of safety
with regards to lamination equipment.
Any commissioning or service engineer
must be of competent nature, trained and
qualified to GBC Pro-Tech standards to fulfill
that job. This person will have completed and
passed the full service training course from
GBC Pro-Tech.
Any GBC Technician, GBC Specialist,
and / or GBC Pro-Tech Technician that has
been through the GBC Pro-Tech service
training course.
Glossary of terminology
Page 10 - 1
Advertisement
Table of Contents
