Table of Contents
Advertisement
Titan 165/ 110 Technical Service Manual
a) Turn the MAIN POWER to the " I " position.
C aution sh ould alw ays b e exercised
w h en using th e lam inator w ith
the safety shields rem oved.
Y ou can be seriously H U R T or IN JU R E D !
b) Remove the main roller safety shield, pressure
plate and feed table.
c) For pressure sensitive adhesives: put on the
rubber gloves and use isopropyl alcohol and a
terry cloth towel.
d) For thermal adhesives: while the laminator is at
normal operating temperature, put on the rubber
gloves and use the rubber cement eraser. This
allows the eraser to bead up the adhesive.
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
© GBC Films Group October 2000
W A R N IN G
CAUTION
CAUTION
Do NOT pick or pull heat activated adhesive
off the rolls when they are cold. You can
cause irreparable damage to the
laminating rolls.
IN F O R M A T IO N
W h en clean in g the low er m ain roller,
rep lace the feed tab le an d p ress R E V E R S E .
W h en clean in g the low er pu ll roller,
p ress R U N to rotate th e roller th en press
S T O P. T his w ill prevent an yth in g from
b eing pu lled into th e n ip .
W h en op erating th e lam inator u sin g the
footsw itch, keep hand s and fin gers aw ay
from the nip of the rollers.
Y ou m ay b e C R U S H E D or B U R N E D !
e) Since the safety shield has been removed, you
must replace the feed table and use the footswitch
to rotate the bottom rollers after cleaning a section.
Servicing
W A R N IN G
Page 1 - 3
Advertisement
Table of Contents
