Table of Contents
Advertisement
Calibrations
d) Inspect the nip impression in the web of the
laminate for eveness across the entire width. If
the thickness of the nip impression looks even,
STOP here. If not, continue with next step.
G ood nip
N ip impression
B ad nip
e) With a 3 mm allen wrench, remove the lift handle
from the control side cabinet.
f) With a 2.5 mm allen wrench, remove the upper
and lower unwind brake handles.
g) With a #2 phillips head screw driver, remove
both cabinets.
Page 2 - 2
Titan 165/ 110 Technical Service Manual
h) Use the small flat tip screw driver to remove the
contact block to the emergency stop buttons.
i) Use the small flat tip screw driver to remove the
control panel from the cabinet.
j) Adjust the springs on the lift assembly plate for
the main rollers as needed to achieve an even nip
impression across the width of the web.
M a in ro lle r n ip
a d ju s tm e n ts
k) When finished, replacethe drive side cabinet, the
control side cabinet, the unwind brake handles
and the lift handle.
© GBC Films Group October 2000
Advertisement
Table of Contents
