Safety Notices - Machine Cleaning; Safety Notices - Service And Maintenance Electrical And Control Systems - GBC DELTA Operator's Manual

Operator Manual
1.10 SAFETY NOTICES – MACHINE CLEANING
!
WARNING
Obey the following precautions. Failure to do so can result in severe personal injury or damage the
machine.
•
Do not clean the machine if it is in operation.
•
Use the "INCH" and "REVERSE" buttons turn the rollers to a different position for cleaning.
•
Use the "INCH" and "REVERSE" buttons as follows:
a. Press the "INCH" or "REVERSE" button.
b. After releasing the "INCH" or "REVERSE" button, wait till the machine stops.
c. Start cleaning the rollers or any other operation only when the machine has stopped.
•
Be very careful when cleaning the laminating rolls, because the roller surface temperature
reaches 300 °F (150 °C). Always use rubber gloves for cleaning the laminating roller.
•
Do not press the "PRESSURE ROLL CLOSE" button while cleaning the pressure roller or the
machine if the operator's hands are close to the pressure roller arms.
Important
•
Do not use aggressive solvents for cleaning the rubber coated rollers, which can affect or
damage the rubber coating.
1.11 SAFETY NOTICES – SERVICE AND MAINTENANCE ELECTRICAL AND
CONTROL SYSTEMS
Guidelines for Safe Maintenance
Only GBC Service is authorized to troubleshoot, repair, or adjust the electrical and control systems.
20
Delta Laminator
© 2004 General Binding Corporation