Important Safeguards; General; Electrical; Service - GBC TALON 44 Operation And Maintenance Manual

IMPORTANT SAFEGUARDS

WARNING: TO GUARD AGAINST
INJURY, THE FOLLOWING SAFETY
PRECAUTIONS MUST BE OBSERVED IN THE
INSTALLATION AND USE OF THE LAMINATOR.

General

Keep hands, long hair, loose clothing, and articles such
as necklaces or ties away from the front of the heat
and pull rollers to avoid entanglement and entrapment.
The heat rollers can reach temperatures over 300° F.
Avoid contact with the heat rollers during operation or
shortly after power has been removed from the
laminator.
Keep hands and fingers away from the path of the
sharp film cutter blade located at the film exit.
Do not use the laminator for other than its intended
purpose.
Avoid moving the laminator on uneven floor surfaces.
Never tilt the laminator.
Do not defeat or remove electrical and mechanical
safety equipment such as interlocks, shields and
guards.
Do not insert objects unsuitable for lamination or
expose the equipment to liquids.

Electrical

The laminator should be connected only to a source of
power as indicated in these instructions and on the
serial plate located on the rear of the laminator.
Contact an electrician should the attachment plug
provided with the laminator not match the receptacles
at your location.
CAUTION: The receptacle must be
located near the equipment and
easily accessible.
Do not operate the laminator with a damaged power
supply cord or attachment plug, upon occurrence of a
malfunction, or after the laminator has been damaged.
Contact GBC's Technical Service Department or your
dealer/distributor for assistance.

Service

Perform only the routine maintenance procedures
referred to in these instructions.
WARNING: Do not attempt to service
or repair the laminator.
Disconnect the plug from the receptacle and contact
GBC's Technical Department or your dealer/distributor
when one or more of the following has occurred.
- The power supply cord or attachment plug is
damaged.
- Liquid has been spilled into the laminator.
- The laminator is malfunctioning after being
mishandled.
- The laminator does not operate as described in
these instructions.
10
I D