Changing The Network Address Of A Workstation; Enabling Forensic Search On A Workstation; Assigning An Analog Monitor Group To A Workstation; Configuring An Analog Monitor Group - Bosch LTC-1311-20 Configuration Manual

Bosch Video Management System
6.10

Changing the network address of a workstation

Main window >
To change the IP address:
1.
2.
6.11

Enabling Forensic Search on a workstation

Main window >
You must enable Forensic Search on a workstation.
Note:
Enable video content analysis on each encoder. Use the VCA page of the encoder in the
Device Tree.
To enable Forensic Search:

6.12

Assigning an analog monitor group to a workstation

Main window >
You assign an analog monitor group to a Bosch Video Management System workstation. In the
Options dialog box, you can configure that all workstations can control analog monitor groups
regardless of the setting here.
To assign an analog monitor group:

6.13

Configuring an analog monitor group

Main window >
You configure the monitors in an analog monitor group logically in rows and columns. This
arrangement does not have to meet the physical arrangement of the monitors.
To configure an analog monitor group:
1.
2.
3.
4.
5.
Bosch Sicherheitssysteme GmbH
Devices > Expand
Right-click and click Change Network Address.
The Change Network Address dialog box is displayed.
Change the entry in the field according to your requirements.
Devices > Expand
Click to select the Enable Forensic Search check box.
Devices > Expand
In the Assigned Analog Monitor Groups column, select the check box.
Devices > Expand
In the Name: field, type a name for the analog monitor group.
In the Columns: and Rows: fields, enter the desired values.
Drag each available decoder to an analog monitor image on the right.
The logical number of the decoder is displayed as a black number on the monitor image
and the color of this image changes.
If no decoder is available, unassign a decoder from another analog monitor group or
repeat network scan.
Click the Advanced Configuration tab.
Change the logical numbers of the assigned decoders as required. If you enter an already
used number, a message box is displayed.
Configuration Manual
Configuring devices | en
> > Settings page
> > Analog Monitor Groups page
>
Configuration Client | V3 | 2010.07
29