Updating Cctv Keyboard Firmware - Bosch LTC-1311-20 Configuration Manual

164 en | Concepts
25.3.3

Updating CCTV keyboard firmware

1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Close IntuiKey Firmware Upgrade Utility.
11. On the keyboard, press Clr key to exit.
12. Select the desired language with a softkey.
NOTICE!
For starting the bootloader mode directly, you can unplug the power supply from the
keyboard, press 0 and 1 simultaneously, plug In the power supply again, release 0 and 1.
Configuration Client | V3 | 2010.07
On any PC, install the IntuiKey downloader.
Start IntuiKey Firmware Upgrade Utility.
Connect the keyboard with a valid serial cable (refer to Bosch Support if such a cable is
not available) to this PC.
On the keyboard, press Keyboard Control softkey, then Firmware Upgrade.
Enter the password: 0 and 1 simultaneously.
The keyboard is in bootloader mode.
On the PC, click Browse to select the firmware file: for example kbd.s20
Set the COM port.
Click the Download button to download the firmware.
On the keyboard display, Programming is displayed.
Do not press the Clr key now. Otherwise the keyboard is not usable after restart (see
Notice below).
Click Browse to select the language: for example 8900_EN_..82.s20
On the keyboard display, Programming is displayed.
The keyboard restarts. Wait some seconds until the menu for selecting the keyboard
language appears.
The default start display appears.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH