Configuring Camera Properties; Configuring Recording Settings (Only Nvr) - Bosch LTC-1311-20 Configuration Manual

50 en | Configuring cameras and recording settings
2.
3.
To configure stream quality settings:
1.
2.
For detailed information on the various fields, see the Online Help for the appropriate
application window.
9.3

Configuring camera properties

Main window >
To change camera properties:
1.
2.
3.
4.
For detailed information on the various fields, see the Online Help for the appropriate
application window.
9.4

Configuring recording settings (only NVR)

Main window >
(for example
Before you configure the recording settings, configure the stream quality levels.
Note: For recording, ensure that the corresponding NVR is configured properly (Devices >
Expand
NOTICE!
For all encoders, live view settings are also used for pre-event recording.
For encoders that support dual-streaming, the settings for live/pre-event recording, motion
recording, and alarm recording are all configured independently.
For encoders that support only a single stream (e.g., the VideoJet 8004), live viewing and
recording use the same stream. In this case, the recording settings take priority, so the live
view uses the stream quality settings for continuous, motion, and alarm recording. You can
enter a setting for live/pre-event only if continuous recording is disabled.
You can switch the live stream from stream 2 (default) to stream 1 for a workstation
(Devices > Expand
encoder. This setting does not affect pre-event recording.
Configuration Client | V3 | 2010.07
Enter the new name in the Name: field.
You cannot rename default entries.
Click OK.
Select an entry in the list.
Make the appropriate settings.
Cameras and Recording >
In the Camera column, click a cell and type a new name for the camera.
This name is displayed in all other places where cameras are listed.
Only for VRM and Live Only: In the Codec Stream 1 or Codec Stream 2 column, select
the appropriate codec for encoding stream 1 or stream 2.
Only for VRM and Live Only: In the Live Quality column, configure the quality of live
display. For these devices, you can only set the live quality per camera, not per schedule.
Make the appropriate settings in the other columns.
Cameras and Recording > Click
)
> > Disk Storage tab).
>
Configuration Manual
> Settings tab > Override recording settings) or for an
Bosch Video Management System
> Click a Recording Schedule tab
Bosch Sicherheitssysteme GmbH