Configuring The Stream Quality - Bosch LTC-1311-20 Configuration Manual

Bosch Video Management System
2.
To copy one value directly:
1.
2.
To copy a value of a cell to all other cells in this column:

To duplicate a row:

9.2

Configuring the stream quality

Main window >
NOTICE!
For XFM4 encoders configure the maximum bit rate with the value of the target bit rate plus
10%. The maximum bit rate is used when a scene is busy and contains motion.
NOTICE!
Bosch Video Management System uses the two streams in dual streaming encoders as follows:
NVR recording: Stream 2 is used for Live and pre-alarm recording, stream 1 is used for motion
and alarm recording. The streams can be switched (stream 1 for Live and pre-alarm, stream 2
for recording) for a workstation.
VRM recording and local storage: Stream 2 is used for Live, stream 1 is used for all recording
modes.
ARM based firmware: Stream 2 can also be used for recording.
The compression achieved is dependent on the stream quality settings, the image complexity,
and the level of motion in the scene. With these interdependencies, it is possible to over-
specify encoder performance. For example, with a highly complex scene with high motion, the
encoder may not be able to deliver 4 CIF full frame rate on both streams simultaneously. Refer
to your encoder guidelines to help estimate the best settings for your conditions.
To add a stream quality settings entry:

To remove a stream quality settings entry:

To rename a stream quality settings entry:
1.
Bosch Sicherheitssysteme GmbH
Right-click the row with the desired values, point to Copy Row to, and click Selected
Rows.
The values are copied.
Click the row heading of the row that you want to modify.
To select more than one row press the CTRL key and point to the other row headings.
Right-click the cell with the desired value, point to Copy Cell to, and click Selection in
Column .
The value is copied.
Right-click the cell with the desired value, point to Copy Cell to, and click Complete
Column.
The value is copied.
Right-click the row and click Add Duplicated Row.
The row is added below with a new name.
Cameras and Recording >
Click to add a new entry in the list.
Select an entry in the list and click
You cannot delete default entries.
Select an entry in the list.
Configuration Manual
Configuring cameras and recording settings | en
> Stream Quality Settings dialog box
to delete the entry.
Configuration Client | V3 | 2010.07
49