10Gbase-Lr/Lw Xfp Specifications - Avaya 8800 Series Installation Manual

10GBASE-LR/LW XFP specifications

The 10GBASE-LX XFP provides 10 GbE or OC-192 service at a nominal wavelength of 1310
nm. This XFP can attain link lengths of up to 10 km.
The following table lists the transmitter and receiver specifications for the 10GBASE-LR/LW
XFP. The part number of this XFP is AA1403001-E5.
For more information about the 10GBASE-LX XFP, including test and measurement
information, see the IEEE 802.3ae standard.
The10GBASE-LR/LW XFP is supported by the Ethernet Routing Switch 5530(not by the 5510
or 5520), and by the Ethernet Routing Switch 5600Series.
Important:
You can configure the XFP to operate in either LAN or WAN mode, depending on the module
(8683XLR and 8612XLRS are LAN-only modules, and 8683XZR is a LAN or WAN module).
Model numbers ending in R denote a LAN interface; model numbers ending in W denote a
WAN interface.
Table 38: IEEE 802.3ae 10GBASE-LR/LW XFP specifications
MTBF
Center wavelength range
Distance
Link optical power budget
Maximum transmitter and dispersion penalty 3.2 dB at 10 km
Transmitter characteristics
Line rate (nominal)
Average launch power
Minimum side mode suppression ratio
Minimum launch power in OMA minus
transmission and dispersion penalty (TDP)
Minimum optical modulation amplitude
Maximum average launch power of OFF
transmitter
Installation — SFP, SFP+, XFP, and OADM Hardware Components
Parameter
c
10GBASE-LR/LW XFP specifications
Specifications
675 000 hours
1260 to 1355 nm; 1310 nm nominal
Up to 10 km
9.4 dB
10GBASE-LR 10.3125 Gb/s ±100 ppm (10
GbE) 10GBASE-LW 9.95328 Gb/s ±20 ppm
(OC-192)
– 8.2 to 0.5 dBm
30 dB
– 6.2 dBm
– 5.2 dBm
– 30 dBm
August 2013 95