Avaya 8800 Series Installation Manual page 56
Ethernet routing switch hardware components
Hide thumbs
Also See for 8800 Series:
- Troubleshooting manual (484 pages) ,
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages)
Table of Contents
Advertisement
Optical multiplexers
4. Connect the west network backbone fiber optic cable to the OADM west
5. Connect the east backbone fiber optic cable to the OADM east connector.
Job aid
The Avaya passive CWDM optical add drop multiplexer (OADM) sends and receives signals
to and from CWDM SFPs installed in the switch. The OADM adds or drops a specific
wavelength from the optical fiber, and allows all other wavelengths to pass through unaffected.
The OADM supports two separate fiber pathways traveling in opposite directions (east and
west) so that the network remains viable even if the fiber is broken at one point on the ring.
The following figure shows OADM operation and equipment side connections.
For more information about OADM specifications, see
page 101.
56
Installation — SFP, SFP+, XFP, and OADM Hardware Components
connector.
Comments? infodev@avaya.com
Multiplexer specifications
on
August 2013
Advertisement
Table of Contents
