100Base-Fx Sfp Specifications - Avaya 8800 Series Installation Manual

100BASE-FX SFP specifications

The 100BASE-FX SFP provides 100 Mbit/s Ethernet Carrier Sense Multiple Access with
Collision Detection (CSMA-CD) connectivity using multimode optical fiber. The 100BaseFX
uses an LED transmitter. The centre wavelength, spectral width, and optical rise/fall time satisfy
the trade-off curves in the FDDI PMD document (ISO/IEC 9314–3:1900). The supported link
length is up to 2 km over MMF. The part number for this model is AA1419074–E6.
Note:
The 8848GB, 8834XG, 8648GBRS, and 8634XGRS are the only modules that support this
SFP.
The following table describes the 100BASE-FX SFP specifications.
Table 6: IEEE 802.3z 100BASE-FX SFP specifications
Maximum electrical power consumption
Connectors
Cabling
Distance
Wavelength
Link optical power budget
Transmitter characteristics
Transmitter type
Nominal wavelength
Transmit output power (max)
Transmit output power (min)
Spectral width
Minimum extinction ratio
Receiver characteristics
Receiver type
Wavelength range
Receiver sensitivity
Installation — SFP, SFP+, XFP, and OADM Hardware Components
Parameter
100BASE-FX SFP specifications
Specifications
0.8 W
Duplex LC
• 62.5 µm MMF optic cable
• 50 µm MMF optic cable
Up to 2 km using 500 Mhz-km MMF optic
cable
1300 nanometers (nm)
10 deciBels (dB)
LED
1300 nm
-14 dBm
-23.5 to -20 dBm
140 nm (FHWM)
10 dB
PIN photodiode
1270 nm to 1380 nm
-33.5 dBm
August 2013 63