Avaya 8800 Series Installation Manual page 58
Ethernet routing switch hardware components
Hide thumbs
Also See for 8800 Series:
- Troubleshooting manual (484 pages) ,
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages)
Table of Contents
Advertisement
Optical multiplexers
4. Connect the network backbone east fiber optic cables to the east (left) OMUX.
5. Connect the network backbone west fiber optic cables to the west (right) OMUX.
Job aid
The Avaya passive optical multiplexer/demultiplexer (OMUX) sends and receives signals to
and from SFP transceivers installed in the switch. It multiplexes and demultiplexes four or eight
CWDM wavelengths from a two-fiber (east and west) circuit. Use the OMUX to create
unidirectional network traffic rings or point-to-point links.
For more information about multiplexer specifications, see
page 101.
The following figure shows the OMUX-4 version with four CWDM SFP side connections.
58
Installation — SFP, SFP+, XFP, and OADM Hardware Components
The SFP wavelength must match the OMUX equipment connector wavelength.
The TX of one device must always connect to the RX of the next device.
Comments? infodev@avaya.com
Multiplexer specifications
on
August 2013
Advertisement
Table of Contents
