Successful Installation Verification - Avaya 8800 Installation Manual

Chassis installation fundamentals
a configured AT-compatible modem to allow dial-in access to startup configuration and
diagnostics.
Hardware for mounting the chassis in an equipment rack
The hardware required to mount the 8010co chassis in an equipment rack depends on your
equipment rack type.
You need a Phillips screwdriver to install the 8010co chassis in a standard rail-type equipment
rack.
The racks must meet the following specifications:
• Heavy-duty steel construction
• Electronic Industries Association (EIA) standard hole spacing
• Two-post rack with a width of 19 in. (48.26 cm) and a depth of 24 in. (60.96 cm)
• Two-post rack with a width of 23 in. (58.42 cm) and a depth of 24 in. (60.96 cm) (Requires
an EIA 19 to 23-in. adapter. Contact your rack manufacturer to order the adapter.)
If the rack does not use threaded rail holes, you must use the supplied clip nuts with the clip
nut screws.
Cables
Unless you specifically order them, Avaya does not include the cables required for your network
configuration in the 8010co chassis accessory package. If you require the proper cables,
contact your network administrator.

Successful installation verification

In a normal power-up sequence, the LEDs light as follows:
• After you apply power to the switch, the green LED on each power supply and fan tray
lights, and the Online LED for each module lights amber.
• Each module initiates a self-test, during which the port and module LEDs display various
patterns to indicate the progress of the self-test.
• Upon successful completion of the self-test (within 2 or 3 minutes after you apply power
for a fully-loaded chassis), the module Online LED transitions from amber to green.
• After 1 minute of operation, the fan tray Pass LED lights steady green.
If the LEDs on the modules light in this sequence, your installation is successful. Contact your
network administrator to verify that the Avaya Ethernet Routing Switch 8800/8600 is now
connected to the network.
If the LEDs do not light in this sequence, contact your local Avaya Technical Solutions
Center.
40 Installation — Chassis
Comments? infodev@avaya.com
November 2012