Successful Installation Verification - Avaya Ethernet Routing Switch 8300 Series Installation Manual

Chassis installation fundamentals
Cables
Unless you specifically order them, the cables required for your network configuration are not
included in the chassis accessory package. If you do not have the proper cables, contact your
network administrator.
Mounting hardware for the 8310, 8306 chassis
To install the Ethernet Routing Switch 8310 or 8306 chassis in an equipment rack, you require
a Phillips screwdriver and an equipment rack that meets the following specifications:
• heavy-duty steel construction
• Electronic Industries Association (EIA) standard hole-spacing
• width of 19 inches (in.) (48.26 centimeters [cm]) and depth of 24 in. (60.96 cm)
For information about chassis weight including components, see
weight including components

Successful installation verification

In a normal power-up sequence, the LEDs light as follows:
1. When power is applied to the Ethernet Routing Switch 8300 Series, the green LED
2. Each module initiates a self-test, during which the port and module LEDs display
3. On successful completion of the self-test (within two or three minutes after power
If the LEDs on the modules light in this sequence, your installation is successful. Contact your
network administrator to verify that the Ethernet Routing Switch 8300 Series is now connected
to the network.
If the LEDs do not light in this sequence, contact your local Avaya Technical Solutions
Center.
30 Installation — Chassis
on page 34.
on each power supply and fan tray turns on, and the Online LED for each module
lights amber.
various patterns to indicate the progress of the self-test.
is applied for a fully loaded chassis), the module Online LED transitions from amber
to green.
Procedure job aid: Chassis
May 2011