Using The Servopack With Single-Phase, 200-V Power Input - YASKAWA Σ-V Series User Manual

3 Wiring and Connection

3.1.4 Using the SERVOPACK with Single-phase, 200-V Power Input

3.1.4 Using the SERVOPACK with Single-phase, 200-V Power Input

Some models of Σ-V series three-phase 200 V power input SERVOPACK can be used also with a single-phase
200 V power supply.
The following models use single-phase 200 V power input.
SGDV-R70A, R90A, 1R6A, 2R8A, 5R5A
When using the SERVOPACK with single-phase, 200 V power input, set parameter Pn00B.2 to 1.
The SGDV-120AE5A008000 SERVOPACK has specifications for a single-phase, 200-V power supply, and
so a single-phase, 200-V power supply can be used without changing the parameters.
(1) Parameter Setting
Single-phase Power Input Selection
Pn00B
• If single-phase 200 V is input to a SGDV-R70A, -R90A, -1R6A, -2R8A, or -5R5A SERVOPACK with a sin-
gle-phase power input without changing the setting of Pn00B.2 to 1 (single-phase power input supported),
a main circuit cable open phase alarm (A.F10) will be detected.
• The SERVOPACK models, SGDV-R70A, -R90A, -1R6A, -2R8A, and -5R5A, support single-phase 200 V
power input. If a single-phase 200 V is input to the SERVOPACK models that do not support single-phase
power input, the main circuit cable open phase alarm (A.F10) will be detected.
• When using a single-phase 200 V power supply, the SGDV-R70A, -R90A, -1R6A, -2R8A, or -5R5A SER-
VOPACK may not be able to produce the same linear servomotor force-speed characteristics as using a
three-phase 200 V power input. Refer to the diagram of each linear servomotor force-speed characteris-
tics in
(2) Main Circuit Power Input
Connect a single-phase 200 V power supply of the following specifications to L1 and L2 terminals.
The specifications of the power supplies other than the main circuit power supply are the same as for three-
phase power supply input.
Terminal
Symbols
L1, L2
∗1. Do not use L3 terminal.
∗2. The official model number is SGDV-120AE5A008000.
3-12
Parameter
Enables use of three-phase power supply for three-phase
n. 0
SERVOPACK. [factory setting]
Enables use of single-phase power supply for three-phase
n. 1
SERVOPACK.
Σ
-V Series Product Catalog (KAEP S800000 42).
Name
Main circuit power
input terminals
*1
–
L3
Meaning
WARNING
Model SGDV- A
R70, R90, 1R6, 2R8, 5R5
Single-phase 200 V to 230 V
*2
Single-phase 220 V to 230 V
120
R70, R90, 1R6, 2R8, 5R5 None
When Enabled Classification
After restart Setup
Rating
+10%
, (50/60 Hz)
−15%
+10%
, (50/60 Hz)
−15%