Chapter 9: Setting Telephone Options
To view the connection status of the Teleworker client telephone
1. At the Teleworker client telephone, access the User Options menu as described in
Displaying the User Options Menu on page
2. Select Teleworker on the User Options menu, or press 8 on the dialpad.
3. Select Status on the Teleworker menu, or press 2 on the dialpad.
One of the following messages is displayed:
When Local (No Teleworker) is displayed, Teleworker mode has not been enabled.
●
See
page 81
When Idle is displayed, Teleworker mode is enabled and the telephone is idle.
●
When Connecting... is displayed, the Teleworker client telephone is attempting to
●
connect to a Teleworker server host—a session has not been established. The host IP
address of the Teleworker server is also displayed in the display area.
When Connected is displayed, the Teleworker client telephone has connected to the
●
Teleworker server host successfully and can access the remote one-X Quick Edition
network. The host IP address of the Teleworker server is also displayed in the display
area.
When No Server is displayed, an IP address for the remote Teleworker server host is
●
required but has not been specified. See
Teleworker server
Note:
A Teleworker client telephone cannot act as a server for another Teleworker client
Note:
telephone. If an IP address has been specified and the IP address belongs to a
Teleworker client telephone, the No Server message will be displayed.
When Not Authorized is displayed, the Teleworker server host does not recognize the
●
Teleworker client telephone and the Teleworker server host refuses the connection.
When Restart Required is displayed, the Teleworker server has uploaded a new
●
configuration to the Teleworker client telephone. The configuration will not take effect
until the Teleworker client telephone is restarted. Press the OK softkey to restart the
Teleworker client telephone.
When Server Busy is displayed, the Teleworker server host is occupied with
●
connections to two other Teleworker client telephones and cannot accept a third
connection. The Teleworker client telephone will contact another Teleworker server
host for a connection automatically.
When No Response is displayed, the Teleworker server host was unable to
●
acknowledge the connection request from the Teleworker client telephone within a
predetermined amount of time. If the Teleworker server host is unavailable, it may be
because your Internet connection is down, your router or firewall has not been
configured to pass P2P packets through a VPN tunnel correctly, or the Teleworker
server host has been disconnected from the one-X Quick Edition network. Provided
82
Avaya one-X Quick Edition Release 2.0.0 Telephone User Guide
To enable or disable Teleworker mode on a Quick Edition IP Telephone on
to enable Teleworker mode.
on page 83 to specify the IP address.
69.
To specify the host IP address of a
July 2006