Installation Procedures - Mitsubishi Electric CR800 Series Instruction Manual

2Unpacking to installation

2.2.3 Installation procedures

The installed size is shown as follows.
When installing the controller horizontally, only one controller can be stacked on top of another controller.
Fig.2-2 ： Installation dimensions
CAUTION
CAUTION
2-8 Installation
When installing the controller vertically, ensure that the air intake is at the bottom as
illustrated in Fig. 2-2.
Fixing installation section sure for prevention from the fall, when using the controller
placing vertically. The reference figure of the metal plate for fixing is shown in
You should install the metal plate for fixation to the controller with M4 x 8 or the shorter
screw. The screw projection length inside the controller (side board thickness is 1.2 mm)
surely makes 6.8 mm or less.
Fig. 2-3.