Installing The Option Devices; Installing/Removing The Option Card; Installing The Option Card - Mitsubishi Electric CR800 Series Instruction Manual

3 Installing the option devices

Refer to Page 47, "4.2.1 Installing and removing the T/B"
"Standard Specifications" or each option's manual for the optional devices other than those described in this
manual.

3.1 Installing/removing the Option Card

CAUTION

3.1.1 Installing the Option Card

The following describes where and how to install the interface card.
Fig. 3-1 ： Installation of the interface card
1) Turn off the power.
2) Pick the interface cover removal lever and pull up the interface cover.
3) Insert the interface card in SLOT1 or SLOT2.
Insert the card as both ends of the card may fit into the guide of slot (SLOT1 or SLOT2 showed in
1).
4) Insert the connection connector securely to the back until the removal lever is locked with the sound.
The installation of the interface card is completed.
When installing or removing the interface card, it is required to keep the interface card
in parallel with the controller.
for installing method of T/B. Refer to the separate
Installing/removing the Option Card 3-39
3Installing the option devices
Fig. 3-