Omron LD-105CT User Manual page 183

Callout
A
B
C
D
E
Replacing Brake Lever Cable
To replace the cart brake-release cable:
1. Remove the cart top plate. See Removing Top Plate on page 156.
2. Disconnect the end of the cable from the brake control mechanism.
a. Disconnect the inner wire from the lever cable clamp.
b. Disconnect the lever cable from the lever cable anchor.
3. Feed the lever cable out through the hole in the horizontal back bar of the cart.
You will need to cut the cable tie at the saddle.
4. Disconnect the brake-release lever from its mounting place.
This will vary, depending on how and where you mounted it.
Adjusting the Lever Cable
The brake lever cable needs to be adjusted so there is no excess slack, but so the brakes are
engaged when the lever is not being actuated.
14766-000 Rev H
A
B
D
C
Figure 10-26. Internal Brake-Release Mechanism
Description
Right Brake Cable
Right Brake Adjust
Lever Cable
Pulley
Lever Cable Anchor
LD Cart Transporter User's Manual
K
H
G
F
E
Callout Description
F Actuator Bar
G Actuator Bar Hard Stop
H Left Brake Cable
I Left Brake Adjust
K Lever Cable Clamp
Chapter 10: Maintenance
I
183