Omron LD-105CT User Manual page 180

10.9 Replacing Non-Periodic Parts
1. Remove the M10 screw and washer holding the caster to the cart.
Threadlocker was used on this screw during assembly.
Retain the screw, washer, and lock washer for mounting the new caster.
2. Remove the caster from the cart.
Front Caster Installation
1. Put the new caster in place, and attach with the M10 screw and washers you removed
from the old caster.
Use Loctite 263 on the screw.
2. Torque to 73.2 N·m (54 ft-lbf).
Rear Caster Removal
The two rear casters are the same as each other, but different from the front casters, due to the
fact that the rear casters have brakes.
1. Remove the top plate of the cart. See Removing Top Plate on page 156.
2. Unscrew the lock nut from the axle screw going through the caster wheel.
3. Remove the axle and caster wheel.
The axle screw, lock nut, and caster wheel can be discarded.
180
Figure 10-24. Front Cart Caster Screw Assembly
LD Cart Transporter User's Manual 14766-000 Rev H