Table of Contents
Advertisement
10.6 Accessing the Payload Bay
Docking Station Contacts
The two docking station contacts occasionally need to be cleaned. The suggested interval is 3-6
months, depending on frequency of charging.
Clean the contacts with isopropyl alcohol.
!
10.6 Accessing the Payload Bay
The payload bay is the area between the platform top plate and the top of the platform itself.
Care must be taken, when accessing the payload bay, that the wires and connections between
the platform and the HMI post and coupling plate are not damaged. See Top View of an LD
Platform Cart Transporter, Side Laser Support Tubes Removed on page 146.
The top plate is held on with eight M6 socket-head screws and two M5 cap screws. You
should not remove the HMI post base. The sheet metal cover of the Latching Mechanism
needs to be removed to access the two M5 screws. The top plate and the rest of the coupling
plate will come off together.
!
Removing Latching Mechanism Cover
1. Remove the four M3 screws holding the Latching Mechanism cover to the top plate.
These go into four 45 mm standoffs in the top plate.
Retain the M3 screws for reassembly.
2. Lift off the Latching Mechanism cover.
Retain the cover for reassembly.
Removing Top Plate
1. Remove the two stainless M5 screws that were covered by the Latching Mechanism
cover.
Retain the M5 screws for reassembly. These are socket-head cap screws.
2. Remove the eight M6 screws along the sides and front of the top plate.
156
WARNING: ELECTROCUTION RISK
Unplug power from the docking station before cleaning. Remove the power
cord at the docking station.
CAUTION: PROPERTY DAMAGE RISK
Do not lubricate the docking station paddle. Lubrication will reduce the life of
the paddle.
CAUTION: PROPERTY DAMAGE RISK
When lifting the top plate off, take extra care not to scratch the coupling laser's
lens with the top plate itself.
LD Cart Transporter User's Manual
14766-000 Rev H
Hide quick links:
Advertisement
Table of Contents
